Page 1 of 1
Preparing the battery for the car
Posted: Fri 14. Dec 2012 15:35
by simon
The car is getting the power from the battery, but not from the poles, + is from the top as normal, but - is from the side of the battery, therefore it is necessary to remove some of the plastic from the battery.
Use a sharp cutter/knife and cut approximate 10 mm from the bottom to remove the plastic.
Re: Preparing the battery for the car
Posted: Fri 21. Dec 2012 22:39
by Keld
thx Simon, but I think a little bit more has to be removed, I had problems with some of them in the cars today, if you got time take ½cm more of each please.
Re: Preparing the battery for the car
Posted: Sat 22. Dec 2012 13:02
by simon
received a new bunch of batteries today
42,99 mm long
the old ones are 43,69 mm
same type Trustfire 10440
that gave a problem in some of the controllers, the battery fall out or it didn't work at all, now we has to fix the controllers to handle these or mark them for cars only, where there are no problem.
so fellow MAGracers, take notice if the batteries are same length.
Merry X-mas lads