MAGracing Forum

After having a lot of information on this forum, i decided to make my first track!

I wanted that my track withdraws against the wall to win some place.

Dimension is 3m x 1m70
It's very heavy but it's possible to withdraws the track alone.......


Here is where i'm in . I used the dremelsaw technic. It's very easy.



I'm not sure how to make lane change. I tried like this :




By leaving a space of 2cm. it is look like ok....but perhaps there is a better solution ?

Thanks for your help!!

Bye

Make it more softly, the way is to not simulete the Scalextric style. Wes says 35mm gap and the paralell to 2 mm.
Then bend!
But I will trye to make something simul as r during christmas when I m home.
Good shoot so far says Lasp

I began to paint the track.

Coming together great! Did you solve the LC problem? Regards Jens

Hi everybody !
For lc, i left a space of 2cm instead of the metal plates! Like my picture.
It's ok but if you drive very slowly, when you turn the steering wheel , the car can go out but it's unusual.

I worked all this week end on the track and it's look like that....



It is not finished.

Bye bye

it looks really good , now we need to see some video from the race

and the silver car on the gray track is hard to see, you need more burn outs so the track getting darker

Fantastic well done , looking forward to starting mine

Thanks!

I ordered 2 additional car today....
I shall take a video but i don't know how to put it on the forum?

I try to finish the track decoration...today i made the pits