test track

[matt]

Car / batterys and charger ordered so time to start the test track . just marked this out on an 8' x 4' sorry for the rubish pic, hopfuly you can see the lines , coments please .

[matt]

clockwise direction , bottom right hand corner results in a crash if you dont turn , single file only after the s bend ,defalt after s will be the inside , at the moment only two chances for the inside to get to racing line.

[matt]

wire gap 3 1/2 inch , inside radius 7 inch smallest .

[Lasp]

Nice first track.
Take it more out at the edge, get fence, remeber its easy to run back with a MR car.
I gues you will hav problems with the narrow corner, but sometimes you are able to just spin around the tweky corners.

But just do it and get nowledge, MR its new for all of us.
Its not nessecerly with constant width betwen the lines. Its not so in real life!

Good luck.

[matt]

thanks , im going to try it i think . but the big question plaster or dremel

[Lasp]

First, concerning corners, just freerun a car and se wath radius you get!
It can be differentierad for left or right.
If you glue the wire to a flat surface, its more easy to understand and correct Lc.
You can ewen test the track with the free glued wire and lc bye just adjusting the nutts that holds the magnetic swing arm.
Good luck says Lasp

[matt]

Well ive started cutting the lines , wanted to use the keld/ dremel method but had to go for
the "cant spend any more cash so have to make something from the shed method" .

[matt]

cheers wes this is fun

[Lasp]

Rely good matt!
I like that trapp in upper right, I can se that your LC works very well.
Please take pictures ewen on that!

Good Luck and Lasp is waiting for more

[matt]

for you lasp