Just to find out if it works: 1/24 scratch build chassis

[rex craemer]

[rex craemer]

hello, i wrecked an old revell heli and put the electronic into my car just to test.i cant steer,but i can handle the speed with this bad ir.transmitter.its enough to test the setup of the tires and the magnets. hope that the new electronic from wes fits in the old chassi

[rex craemer]

the car works good, i installed the 5x5 magnets,normaly to pull out the akku,as the guiding magnet, i drilled it up in the original guidearm.also i changed the sidemagnets. i used two original guidemagnets 4 mm.this will give more magnetforce to the frontaxle. i have to look what happens,wen i can steer. i tested it and it works,drifts are possible.had a problem at highspeed (very high with this gear ) the frontaxle starts to dance.i sanded down the fronttyres until only a small ring of rubber will touch the ground on the inside of the tyre,near or better direct at the point were the axle turns,and its silence in the front. its interesting to see ,how much more power you have to give the frontaxle,because of longer wheelbase and higher weight .i am afraid it will not operate correkt with the original wire. on straits ok but in curves i think we have to use a bigger wire i will test with a mix soon.i have so much projekts that i dont know what to do first.i will write over failure and progress.i wonder that the micro esc.can handle the two motors without smoking wish all much fun markus

[rex craemer]

[rex craemer]

hi, me again.iwas not happy with the sanded fronttyres,so i tryed ,,o,,rings and its working great. its so good that i smoked my test speedcontroler.its realy fast and holds the line .

[rex craemer]

[rex craemer]

[rex craemer]

[rex craemer]

[rex craemer]

that was the rc equipment in the car ,wonder that it lives as long as it did.